facebook pinterest

Revak Nursery

24066 Pillsbury Avenue
Lakeville, MN 55044
Map/Location

Elko-New Market Farm

6291 E. 240th St.
Elko, MN 55020
Map/Location
0 Comments

Porch Pot Reindeer

Want to create a cute reindeer you can add to a pot near your front door, use  on a Christmas tree and have some fun with your kids?  Check out this project.

Supplies:  1 large pine cone, 1- 3/8" dowel ( I used one 36" long, because I am using the reindeer in a tall urn), 3--19" white crazy stems (19" long, fat chenille stems), 1--64" length of rustic wire, cut into 4 equal pieces (heavy duty wire covered with twine), 1 small red pompom, 2 beads for eyes, 1--32" length of ribbon, and glue.

Tools: wire cutters, glue (If you plan to use your reindeer outside, use skillet glue, if you are planning to use it indoors, you can use most any heavy-bodied adhesive (avoid thin adhesives such as super glue.)

 1.  Lay the pine cone on its side.  Drill a hole in the bottom of one of the long sides, near the middle.

 2.  Glue the dowel into the hole you've just made.

 3.  Lift pine cone on dowel and begin placing the red pompom as the nose and the beads for eyes and glue them into position.

 4.  Using wire cutters, cut the rustic wire into 4 equal pieces.  Twist two pieces several times at the bottom and spread the tops out to form two branching antlers.  Glue into place.  

5.  Cut one of the white crazy stems into two pieces and wind each piece on a flat surface to form two small fuzzy circles.  These are the earmuffs.  Glue them to the pine cone, placing them just below the antlers.  

6.  Wrap the last crazy stem around the dowel just below the bottom of the pine cone to form his collar.  

7.  Glue the inside, back of the ribbon to the dowel and tie the ribbon just below the collar into a bow.

 

 porch-pot-reindeer

 DSC_0168


Comments

0 Comments
Security Check
Please enter the text below
CaptchaImage
Can't read text above? Try another text.
MNCTA_logo MN_Grown_logo Trustwave_logo Trees_for_Troops_logo Go_Green_logo